As the name suggests, descaling your hot water dispenser is a process where you take the normal supply piping and route it elsewhere. It sounds complicated, but really it’s not. There are few simple steps to follow when you decide to descale your system. By following those steps, you can easily descale your system and have it operating at full power and efficiency.
The first thing you need to do is figure out the temperature of your supply pipe. Knowing the temperature is critical because it determines how fast the hot water will heat up. To find this, you just need to take a measurement of the inside of the pipes near where you would like to put the hot water heater. Once you have this information, you will be ready to descale your hot water dispenser! Below, you will find several instructions and tips to help you descale your system.
The first thing you must do is drain the water out of the tank on your dispenser. You may need to turn off the power, depending upon whether or not there is a heating element in your dispenser. Next, you must open the valve that is located on top of the dispenser. You can do this by either unscrewing it or by pulling up a lever. Once you have done this, you can pour the rest of the supply water into your new container.
When you are done, close the valve again. You should also remove the hose that is attached to your dispenser. After that, you must attach the hose to the hose that is connected to the tank. This way, you will be able to pour the hot water from the dispenser directly into the hose.
Next, you must drain the tank. This process is relatively easy. You just have to detach the water pump from the bottom of the tank and then lower it down. Once it is done, you can flush out the tank with some water. On the contrary, if you are using a tank with a larger capacity, you may use water and soap mixture to make it fill up the tank again. Just make sure that you have sufficient amount of soap so that you won’t be cleaning the tank for a few days.
If you still have the same question “Can I descale my hot water dispenser?” – here is another answer for you. You must open the valve of the dispenser. After that, you can pour the supply water into the dispenser, which has the similar valve as the one you used earlier.
Dispensers with large capacity may need more than one tank. If you want to descale your hot water then you have to open all the valves of the dispensers except for the last one. This way, the supply of hot water will come from different parts of the dispenser. When it is complete, you can close the valve you were using. The remaining supply of hot water should be enough for your need.
Descaling hot water dispensers is not difficult. It is not something that you need to worry about when you are using one. Just follow these simple tips and you will surely have a great dispenser.
First of all, you need to turn on the hot water supply valve. When the supply is complete, you have to release it. Now go to the area of the tank where the used water is stored. This area will be easy to get to because there are holes all over the tank dispenser.
Second, you should locate the part of the tank that is filled with water. In order to do this, you must open the valve and look inside the dispenser. The used water will fill the tank and the bottom part of the tank will have more than enough water to cover all the people who live in the house. When you have found the spot that you can locate the used water, you should pull a nozzle and release the hot water from the tank. It is easy to reach because of the holes that were already present.
Last but not least, you should close the valve. When you have closed it, you can start your hot water supply by turning on the shower head inside the dispenser. The pressure will build inside and make the water flow. Those are the steps that you have to follow when you want to know “how can I descale my hot water dispenser?”